posted Apr 20, 2009, 10:02 AM by Unknown user
[
updated Apr 20, 2009, 10:01 AM
]
- We start doing the 4 level of the crane.
|
posted Apr 20, 2009, 9:59 AM by Unknown user
[
updated Apr 20, 2009, 9:59 AM
]
- We research about how to use the stepper motor with the arduino table.
|
posted Apr 20, 2009, 9:51 AM by Unknown user
[
updated Apr 20, 2009, 9:54 AM
]
- We connect the wires and the motor to the linear motion device.
- We add a 9 volt battery to make it move.
|
posted Apr 20, 2009, 9:48 AM by Unknown user
[
updated Apr 20, 2009, 9:56 AM
]
- We take apart a printer to obtain the ink cartage, that there, we will put the arduino board.
- We also take the slider.
- We use it to make the linear motion device.
|
posted Apr 20, 2009, 9:44 AM by Unknown user
[
updated Apr 20, 2009, 9:46 AM
]
- We continue making the structure.
- We have now 3 stories of the structure.
|
posted Apr 8, 2009, 7:20 AM by Unknown user
[
updated Apr 8, 2009, 7:20 AM
]
- We continue making the structure
- We adjust the 14 cm long tubes to 13.75 to fit long sides.
- We start glueing the tubes to make the structure.
|
posted Apr 8, 2009, 7:14 AM by Unknown user
[
updated Apr 8, 2009, 7:15 AM
]
- We start the project.
- We make trails for tubes made of paper.
- 10.25 cm the sides and 14 cm long.
- We start the designs.
|
|