Electronics Class > Logs for Fall 2009 >
Robot Car
01/13/10
Problem with motor, spent day fixing it and adding comments to program Clark: commented on program Scheuer: soldered Plona: took apart the car and attempted to find the problem |
01/12/10
Tested car, changed program, replaced broken Whisker Clark: Changed Program Scheuer Soldered Plona: fixed whisker |
01/11/10
Did dry runs with the robot to test amount of time needed to turn Clark: Changed the times in the program Plona and Scheuer: Watched car and fixed any problems that occured |
1/08/10
Edited program to fit one push button, replaced faulty battery clip, set up push button, and soldered the push button pieces to circuit board Clark: found battery clip, edited program Scheuer: soldered push button pieces, set up push button Plona: Replaced clip, set up push button |
1/07/10
Right motor wasn't working, so we spent the time trying to fix it and succeded. Plona and Scheuer: checked circuitry Clark:checked program |
1-6-10
today we fixed a couple motor issues and started the whiskers. We tried to fixed the program but some technical issues did not permit that. Clark: didnt show up Plona: did blogs and tired to fix programing Scheuer: soldered the motor so it worked |
1-5-10
today we tried to fix the programing. AGAIN. Clark was too lazy to write this yesterday so im doing it for him Clark: copied and pasted an old program. it didnt work Plona and Scheuer: encouraged Clark to fix the program |
12/18/09
Finished the program(had to fix the numbers, and change to one button), set up the car Adam Clark: finished/fixed program Jake Plona: set up car Alex Scheuer: set up car, soldered |
12/16/09
Basic H-Bridge set up Alex Scheuer: Soldered chip pieces Jake Plona: Set up chip pieces Adam Clark: typed the journal |
12/15/09
Finished comments on program, finished up soldering until H-Bridge clip comes Alex Scheuer: Finshed soldering Jake Plona: FInshed soldering Adam Clark: finished comments Final Program is in attachment |
1-10 of 16